LSI 9690SA-8E-KIT Guide d'installation télécharger pdf (Page 85)

Unit Object Commands

www.lsi.com/channel/products 77

/cx/ux show storsave

The /cx/ux show storsave command shows the storsave policy on the unit.

For more information see, “/cx/ux set storsave=protect|balance|perform

[quiet]” on page 84.

Example:

//localhost> /c0/u5 show storsave

/c0/u5 Command Storsave Policy = protect

/cx/ux show verifystatus

The /cx/ux show verifystatus command shows the verifystatus (if any) of the

specified unit.

Example:

//localhost> /c0/u5 show verifystatus

/c0/u5 is not verifying, its current state is OK

/cx/ux show volumes

The /cx/ux show volumes command shows the number of volumes in the

specified unit. Normally there is one volume unless autocarving is enabled

and/or a boot volume was specified.

Example:

//localhost> /c0/u0 show volumes

/c0/u0 volume(s) = 1

/cx/ux show all

The /cx/ux show all command shows the current setting of all unit attributes.

Example:

//localhost> /c0/u1 show all

/c0/u1 status = OK

/c0/u1 is not rebuilding, its current state is OK

/c0/u1 is not verifying, its current state is OK

/c0/u1 is not initializing, its current state is OK

/c0/u1 Write Cache = on

/c0/u1 Read Cache = Intelligent

/c0/u1 volume(s) = 2

/c0/u1 name = myarray

/c0/u1 serial number = C6CPR7JMF98DA8001DF0

/c0/u1 Ignore ECC policy = on

/c0/u1 Auto Verify Policy = on

/co/u1 Storsave policy = protection

/c0/u1 Command Queuing Policy = on

/c0/u1 Rapid RAID Recovery setting = all

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 137 138

Pas de commentaire

LSI 9690SA-8E-KIT Guide d'installation Page 85