LSI 9690SA-8E-KIT Guide d'installation télécharger pdf (Page 125)

Enclosure Object and Element Commands

www.lsi.com/channel/products 117

/cx/ex/fanx set identify=on|off

The /cx/ex/fanx set identify command applies only to 9750 and 9690SA

controllers. For the 9650SE, simply drop the prepended controller name in the

command and use /ex.

If the enclosure supports Fan Identify and there is an LED associated with the

fan, this command causes the LED associated with the fan to blink, or turns

off identification of the LED for this fan.

Example:

//localhost> /c0/e0/fan1 set identify=on

Setting Fan Identify on /c0/e0/fan1 to [on] ... Done.

/cx/ex/fanx set speed=<0..7>

The /cx/ex/fanx set speed command applies only to 9750 and 9690SA

controllers. For the 9650SE, simply drop the prepended controller name in the

command and use /ex.

The /cx/ex/fanx set speed command sets the speed level of the specified

enclosure fan. The speed level is a number in the range of <0 . . 7>, as

follows:

0 – Off

1 – Lowest

2 – Low

3 – Medium-low

4 – Medium

5 – Medium-high

6 – High

7 – Highest

Example:

//localhost> /c0/e0/fan1 set speed=1

Setting Fan Speed on /c0/e0/fan1 to [1] ... Done.

/cx/ex/pwrsx show

The /cx/ex/pwrsx show command applies only to 9750 and 9690SA

controllers. For the 9650SE, simply drop the prepended controller name in the

command and use /ex.

The /cx/ex/pwrsx show command shows the information about the specified

power supply element /pwrsx in the specified enclosure cx/ex. The power

supply name is followed by its status. The possible status values are OK,

FAIL, NOT-INSTALLED, and OFF. The possible values for voltage are OK,

OVER-VOLTAGE, and UNDER-VOLTAGE. The possible values for current

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 137 138

Pas de commentaire

LSI 9690SA-8E-KIT Guide d'installation Page 125